There are several culprits for this ranging from a dull needle, improper threading or tension. The tension in both your upper and bobbin threads need to be even. The bobbin could also be placed incorrectly. More than likely, you forgot to put the bobbin back correctly while cleaning your machine.
What causes my bobbin thread to bunch up?
A: Looping on the underside, or back of the fabric, means the top tension is too loose compared to the bobbin tension, so the bobbin thread is pulling too much top thread underneath. By tightening the top tension, the loops will stop, but the added tension may cause breakage, especially with sensitive threads.
Why does my sewing machine keep jamming underneath?
The reason for the problem could be lint, dust and other debris getting stuck in their mechanism. The solution: Stop work, lift the presser foot and thoroughly clean the fee dogs from any debris. Also, make sure that they are lifted up in a raised position allowing for a proper grip of the fabric.
Why is my fabric bunching while sewing?
Tension pucker is caused while sewing with too much tension, thereby causing a stretch in the thread. After sewing, the thread relaxes. As it attempts to recover its original length, it gathers up the seam, causing the pucker, which cannot be immediately seen; and may be noticeable at a later stage.
Why is my sewing machine bird nesting?
Bird nests occur when thread bunches up underneath the needle plate, causing broken threads, skipped stitches, or uneven tension. This is typically caused by the top thread not being threaded correctly or a sewing machine tension issue.
How do I stop my sewing machine from bunching up?
A good cleaning may solve your bunching woes (check your manual for guidelines on cleaning and maintenance; your machine may also need to be oiled). To prevent stitch glitches, be sure to frequently dust underneath the throat plate and along the thread path, and to periodically clean and oil your machine.
What tension should my sewing machine be on?
The dial settings run from 0 to 9, so 4.5 is generally the ‘default’ position for normal straight-stitch sewing. This should be suitable for most fabrics. If you are doing a zig-zag stitch, or another stitch that has width, then you may find that the bobbin thread is pulled through to the top.
Why does my sewing machine jam with elastic?
Other reasons for sewing machine jams when sewing elastic include: Dull, old, and worn out needle that you need to replace the needle on the sewing machine to avoid this issue. … Tension settings, especially when the tension is too high for the elastic or fabric, will cause the fabric jams.
How do you adjust the tension on a bobbin?
To tighten your bobbin tension, turn the tiny screw on the bobbin case a smidgen clockwise. To loosen bobbin tension, turn the screw counterclockwise. A quarter turn or less is a good place to start.
What is an overcast foot?
The overcast foot is also known as an over-edge or over locker foot. It is a magical little sewing machine foot that can give you an edging similar to that of an over locker with just about any sewing machine. This is a really simple to use foot, when you have the correct stitch selected.