What can I use to hold beads in place?
Just wrap a piece of tape to the point on your thread where you’d like to start your beadwork. No beads will slip off while you begin, and you can slide the tape off the end of the thread when you’re sure everything’s in place. These little coiled gizmos are great for holding beads in place on stringing wire.
How do you keep beads from rotating?
To stop them rotating beads can also be mounted on very tight wires, or by making tight loops where the wires exit. You can also file a short groove in the hole with a bead reamer and flatten part of the wire with pliers to fit, or tighten a loop against it or, or a hundred and one things.
How do you keep beads in place on string?
Tie one knot to secure the beads in place. Tie this knot as close to the end of the beading as possible to keep the beads from sliding around on the string and revealing the cord beneath. To position the knot as snugly as possible, form the knot loosely, then slide it into place as you tighten it.